Fujitsu ETERNUS User Manual page 40

Chapter 3 Startup and Shutdown
> 3.1 ETERNUSmgr for Solaris OS, HP-UX, AIX, and Linux
activated, and then browse each of the three logs to make sure that communications with all are
normal.
The following message appears when you try to startup ETERNUSmgr by the above procedure
and ETERNUSmgr is running already. ETERNUSmgr must be shutdown before it can be started
up. For instructions on how to shut down ETERNUSmgr, refer to
ETERNUSmgr" (page
/opt/FJSVgrmgr/stxpoll: Already running.
*** stxpoll could not start. ***
As explained in
"STX~.INI" format as a setup file and loads it accordingly. If ETERNUSmgr detects multiple setup
files (for multiple devices), it will load all of them.
ETERNUSmgr automatically reads the setup file(s) at startup. If it fails to locate or read any
setup files, the following message is displayed and startup is terminated.
stxchk: ETERNUSmgr could not start.
Error detail: No INI file.
*** stxpoll could not start. ***
ETERNUSmgr determines the device that is to be monitored according to the "TARGET_ADDR"
parameter specified in the setup file and accesses it accordingly. If a "TARGET_ADDR"
parameter is not specified, or if it is incorrect, the following message is displayed and startup is
terminated.
stxchk: ETERNUSmgr could not start.
Error detail: Invalid host name was defined at "STXPOLL_1.INI".
Please check "TARGET_ADDR" parameter in this file.
*** stxpoll could not start. ***
If ETERNUSmgr detects the "TARGET_ADDR" parameter to be missing, incorrect, or duplicated
in multiple setup files, the following message is displayed and startup is terminated.
stxchk: ETERNUSmgr could not start.
Error detail: Invalid host name were defined at following INI files.
Please check "TARGET_ADDR" parameter in these files.
STXPOLL_1.INI
STXPOLL_2.INI
*** stxpoll could not start. ***
If any such messages are displayed on the screen when ETERNUSmgr is starting up, check that
a setup file exists and all parameter settings are correct.
In addition, the contents of all the displayed messages are logged in the "stxchk.sts" file stored in
the directory in which ETERNUSmgr is installed (this file will be empty if ETERNUSmgr has
started up normally).
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
41).
"2.1 Setup files" (page 15)
"STXPOLL_1.INI" indicates the name of the setup file in which the error
was actually detected.
"STXPOLL_1.INI" and "STXPOLL_2.INI" indicate the name of the setup
files in which the error was actually detected.
40
ETERNUSmgr treats any file that conforms to the
Copyright 2009 FUJITSU LIMITED
"3.1.2 Shutting Down