Download Print this page

Operation - COMFORT-AIRE Room Air Conditioners Installation & Operation Manual

Room air conditioners for double hung windows & through-the- wall installation
Hide thumbs Also See for Room Air Conditioners:

Advertisement

Available languages

Available languages

OPERATION
--'}
Power
Control
The Power Control
turns the unit on and off,
Set
Temperature/Timer
Display
Shows the set temperature
when the unit is in operation
and hours when the timer
is
being set. THE TEMPERATURE DISPLAY ONLY SHOWS THE SET TEMPERATURE, NOT THE
ACTUAL ROOM TEMPERATURE.
Temperature/Timer
Hour
Controls
These buttons
are used to raise or lower the set temperature
in increments
of 1° from
66 ° to 88 °. By depressing
both
buttons
at once, the display will toggle
between
Celsius
and Fahrenheit.
When the timer
is being set, these buttons
are used to change the hour
setting
in increments
of 1 from 00 to 24.
Mode
Control
O
A green light will indicate
which mode is currently
being utilized.
Cool Mode-The
unit will circulate
and cool the air.
Heat Mode (Heat Models
Only)- The unit will circulate
and heat the air.
Heater Safety Feature- When
heater is powered
off, low fan will automatically
stay
on and run for 60 seconds to ensure the removal
of residual
heat, meanwhile,
the
Low Fan LED blinks until the low fan stops.
Fan Mode-
The unit will only circulate
the air.
Energy Saver Mode - The fan will switch from the set fan speed to LOW whenever
the
compressor
turns off in response to the thermostat.
When the compressor
cycles back on,
the unit will return
to the original
fan setting.
Fan
Speed
Control
High, Medium*,
Low and Auto
*MEDIUM
FAN NOT available
on HEAT models.
The settings
are adjusted
with the Fan Speed Control,
each time the button
is depressed
it changes the setting.
A green light will indicate
which setting
is currently
being used.
When
the AUTO feature
is selected while
the air conditioner
is in the COOL or HEAT
mode, the fan speeds will change automatically
as the temperature
in the room changes.
COOL Mode
• 7 ° or more above the set temperature
will use HI fan.
• 4 ° or less above the set temperature
will use LO fan.
HEAT Mode (Heat models only)
• 9 ° or more below the set temperature
will use HI fan.
• 4° or less below the set temperature
will use LO fan.
Timer
Control
The timer can be set to either turn the unit on or off
O
To turn
the unit ON using the
Timer:
Depress the timer
key when the power is off,
the display will read 00. Adjust to the desired number of hours before TURN ON using the
up/down
arrows.The
display will show the time by hours left until TURN ON. To Turn the
timer
off, depress the timer
key. A green light next to the Timer Control
indicates that the
timer
is set.
To turn
the unit OFF using the Timer:
Depress the timer key when the power is on,
the display will read 00. Adjust to the desired
number of hours before TURN OFF using
the up/down
arrows. The display will automatically
return to the set temperature
after 10
seconds.To display the amount
of time left until TURN OFF, depress the timer
button
once.
To turn the TIMER OFF, depress the timer
button
twice.
A green light next to the Timer
Control
indicates that the timer
is set.
O
Power Control
Temperature/Timer
Display
_
emperature/Timer
Controls
Mode
Control
O
Fan Speed Control
O
Timer On/Off
Built-in
three
minute
timing
delay
This
electronic
controlled
unit
will
not
automatically
resume
operation
after a power
failure.
ff this electronic unit will not respond
to
touch
pad
or
remote
control
commands, it is necessary to unplug
the unit from the electrical outlet for
five seconds and then plug the unit
back in.
A
he heat from this unit is designed
only as a supplemental heat
source in addition to
regular heating systems.
Air Conditioner
Remote
Control
/_
_
KAUIION:
• Use only AAA or IEC R03 1.5V batteries.
• Remove
the batteries
if the remote
controller
is not used for a month
or
longer.
• Do not attempt
to recharge
the supplied
batteries
• All batteries
should
be replaced at the same time.
• Do not dispose of the batteries
in a fire as they may explode.
• Do not mix old and new batteries.
• Do not install the batteries
with
the polarity
(+/-) reversed.
Keep batteries
and other things that could be swallowed
away from young children.
Contact a doctor
immediately
if an object is swallowed.
9
o

Advertisement

loading