Table of Contents
Advertisement
Operation of Current Device
(Applicable to the unit adopts current detection device only )
The power supply cord contains a current device that senses damage to the power cord.
To test your power supply cord do the following:
1.Plug in the Air Conditioner.
2.The power supply cord will have TWO buttons on the plug head. Press the TEST button,
you will notice a click as the RESET button pops out.
3.Press the RESET button, again you will notice a click as the button engages.
4.The power supply cord is now supplying electricity to the unit. (On some products this it
also indicated by a light on the plug head.)
NOTE:
Do not use this device to turn the unit on or o .
Always make sure the RESET button is pushed in for correct operation.
The power supply must be replaced if it fails reset when either the TEST button is pushed,
or it cannot be reset. A new one can be obtained from the product manufacturer.
If power supply cord is damaged, it cannot be repaired. It MUST be replaced by one
obtained from the product manufacturer.
NOTE:This air conditioner is designed to be operated under condition as follows:
64-109 F/18-43 C (64-125 F/18-52 C
Outdoor temp:
Cooling
for special tropical models)
operation
Indoor temp:
Outdoor temp:
Heating
operation
Indoor temp:
O
O
O
O
62-90 F/
O
17-32 C
O
23-76 F/
O
-5-24
C
O
32-80 F/
0-27 C
O
O
Note: Performance may be reduced
outside of these operating
temperatures.
Page 7
Hide quick links:
Advertisement
Table of Contents
