Fujitsu fi-5120C Operator's Manual page 123

fi-5120C / fi-5220C Image Scanner Operator
Guide
6.3 Remedying Typical Troubles
Symptom: The scanning does not start.
Back
Did you unlock the shipping lock of the
flatbed?
(fi-5220C only)
Are the document loaded correctly on the ADF
paper chute?
Is the ADF closed completely?
Is the interface cable connected correctly?
Is the connector of interface cable broken?
(when using scanner on SCSI interface)
Is the SCSI ID set correctly?
Does the scanning start after running ON the
scanner again?
YES
YES
YES
YES
Yes
YES
Turn OFF the scanner and unlock the shipping
lock. (*1)
NO
Load document correctly on ADF paper chute.
NO
Close the ADF completely.
NO
Connect interface cable correctly. (*2)
NO
Use a new interface cable and correctly
connect it.
YES
Turn OFF the scanner and set the SCSI ID
correctly, then turn ON the scanner again.
(*2)
NO
The scanner operation is normal.
YES
TROUBLE SHOOTING
CONTENTS MAP
TOP