Chapter 3 Selection of Data and Embroidering
Sewing Operation
Select a hoop to set on the machine.
1.
2.
1.
60
Before Starting Sewing
The following operation should be done before turning the power ON to the
machine. Otherwise, it will damage the hoop.
Select either the flat hoop or cap hoop, using FLAT or CAP switch on the
operation panel.
When a flat or tabular hoop , or a sash frame is set on the machine, select [FLAT].
When a cap hoop is set, select [CAP].
FLAT
HOOP
Specify an embroidery hoop set on the machine, referring to "Embroidery
Hoop" (
Page 85).
Starting Sewing Operation
For details of specifying a sewing start position, refer to "Registration of Sewing
Start Position" (
Page 92).
When
is pressed while the message "Area over" is indicated on the screen,
a dialog box is displayed for confirming whether or not to start sewing forcibly.
Pressing
starts sewing; however, depending on the start position, an
interference with the frame may occur. Exercise added care when doing so.
Check that sewing data has been selected, then press
Sewing is started.
Currently selected speed range
The range can be modified by pressing
BES-916AC • BES-1216AC
CAP
The current embroidering status is indicated.
Indicates a sequence of color changes.
Indicates a name of data currently used for sewing.
Indicates the number of data currently used for sewing.
No. of current stitches
.
.