Table of Contents
Advertisement
When the machine is turned on:
The message "Needle case lock" may appear while a buzzer sounds intermittently. In such a
case, the machine is not ready to start because the needle bar case is not positioned correctly,
and thus the needles are not in proper alignment with the holes of the needle plates. Follow
the steps below to fix this.
BES-916AC
BES-1216AC
e
1. Check if the needles stop in the normal
w
2. Turn knob e slowly.
3. There is a dead zone in which the needle
e
4. Press
5. The message "Moving frame" appears and
6. The main menu appears.
BES-916AC • BES-1216AC
Chapter 1 Preparation of Embroidery Machine
position.
When cam plate w is raised, it is in the automatic jump
position. This is the normal position.
If knob e cannot be turned or is too heavy to rotate,
thread take-up q or the needle bar is not in the normal
position. Check if any obstacle interferes with the needle
end or the presser foot.
Note) Do not turn the knob forcibly.
bar case cannot be moved even by turning
knob e. Turn the knob to the normal
position in the vicinity of the center of the
dead zone.
.
STOP
a buzzer sounds three times. The X and Y
carriages move automatically so as to bring
the hoop center to the home position or to
the position where it was located at the end
of the previous operation.
29
Advertisement
Table of Contents
