Table of Contents
Advertisement
Chapter 2 Embroidering Procedures
Operation panel
42
FLAT
CAP
HOOP
Selects the flat or cap hoop. This selection should be done before turning the power ON
to the machine. The setting will not be changed if the selection is done after turning the
power OFF.
Moves the hoop.
Step-back or forward is available during suspension. (Use
Changes the speed range during embroidering (Use
Carries out inching of the hoop when the switch is pressed in the inching mode.
Move the cursor for selecting sewing data and an icon.
Moves the needle bar. The needle moves by the diameter every time this switch is pressed.
Change to the screen for selecting sewing data.
BES-916AC • BES-1216AC
Contrast volume
Adjusts the screen contrast.
SBUS interface connector
Not used (Do not connects anything.)
RS-232C interface connector
Connect personal computer with BE-100 installed, etc.
switches only.)
switches only).
Advertisement
Table of Contents
