This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys Matrix
information about the CLI (Command Line Interface) set of commands used to configure
and manage the 2G4072‐52, refer to the Enterasys Matrix N Standalone Series Configuration
Guide.
Depending on the firmware version used in the Enterasys Matrix N SA, some features
described in this document may not be supported. Refer to the Release Notes shipped
with the Enterasys Matrix N SA to determine which features are supported.
Who Should Use This Guide
This guide is intended for a network administrator responsible for installing and setting
up the 2G4072‐52.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
®
N Standalone (NSA) Series 2G4072‐52. For
Important Notice
Preface
N Standalone Series Installation Guide xv