Related Documents - Enterasys SecureStack C2RPS-CHAS2 Installation Manual

Related Documents

This preface provides an overview of this guide and the SecureStack C2 manual set, and a
brief summary of each chapter, and the conventions used throughout this guide. To locate
information in this guide, refer to the following table:
For...
The features and capabilities of the C2RPS-CHAS2
chassis and optional power supply modules. This
chapter also provides the instructions for obtaining help
from Enterasys Networks, if needed.
Instructions to install an RPS into a standard 19-inch
rack. This involves installing the C2RPS-CHAS2 chassis,
one or two PSMs, PSM interconnecting cables, and AC
power cords.
Specifications for the C2RPS-CHAS2 chassis, PSM,
PSM cable, Redundant Power Supply connector pinout
descriptions, and Compliance Standards.
Related Documents
Other manuals have been developed for the SecureStack C2 non‐PoE switch devices that
can be connected to the RPS for power redundancy.
The SecureStack C2 switch manuals explain how to install the switch device, connect
network cable segments to the SecureStack C2 switch device, and configure the switch
device using the command line interface commands described in the SecureStack C2
Configuraton Guide.
Each manual is written for qualified personnel responsible for installing the switch device
and also have a general working knowledge of data communications networks and their
physical layer components.
xii About This Guide
Caution: The RPS does not support PoE-compliant C2 switches. Do not try to connect the
power cable from this RPS to any C2 switch with a "P" suffix in the model name, such as
C2xxxxx-xxP. Otherwise, damage to the device may result.
Precaución: El RPS no es compatible con switches SecureStack C2 con PoE. No intente
conectar el cable de corriente del RPS a ningún switch SecureStack C2 que tenga el sufijo
"P" en el nombre del modelo, tal como C2xxxxx-xxP. De lo contrario, el dispositivo puede
dañarse.
Note: Connection of the RPS system does not require reconfiguration of the connected
Ethernet Switch.
Refer to...
Chapter 1, Introduction
Chapter 2, Installation
Appendix A, Specifications