Chapter 2: Installation; Required Tools; Unpacking Chassis And Power Supply Module(S) - Enterasys SecureStack C2RPS-CHAS2 Installation Manual

This chapter provides instructions to install all the components of an RPS.
To correctly install an RPS, follow the order of information listed below.
For information about...

Required Tools

Unpacking Chassis and Power Supply Module(s)

Installing C2RPS-PSMs
Installing C2RPS-CHAS2 into the Rack
Connecting the PSM Cables and AC Power Cords
Required Tools
A flat‐blade screwdriver is required to install the C2RPS‐CHAS2 and C2RPS‐PSMs.
Unpacking Chassis and Power Supply Module(s)
The C2RPS‐CHAS2 and each C2RPS‐PSM are shipped separately. To unpack these
devices proceed as follows:
1.
2.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Open the box and remove the packing material protecting the devices.
Verify the contents of each carton and compare the contents shipped with those listed
in Table 2‐1 and Table 2‐2.
Installation
Refer to page...
2-1
2-1
2-2
2-4
2-6
SecureStack C2 Installation Guide 2-1
2