Connecting The Psm Cables And Ac Power Cords; C2Rps-Psm Cable; Power Connectors On C2Rps-Psm (Rear View) - Enterasys SecureStack C2RPS-CHAS2 Installation Manual

Connecting the PSM Cables and AC Power Cords

Connecting the PSM Cables and AC
The PSMs are connected to the SecureStack C2 Ethernet switch devices using C2RPS‐PSM
Cables.
To connect the PSMs, proceed as follows:
1. Connect one end of the C2RPS‐PSM Cable (shown in Figure
Power Supply connector on the switch device. Then connect the other end to the
Redundant Power Supply connector at the rear of the PSM as shown in Figure
Figure
2. Connect a standard AC power cord to the AC input power connector on the PSM
shown in Figure
3. The green Power LED on the front of the PSM will illuminate to indicate a successful
connection. If the LED remains off, proceed as follows:
a.
b. Check the AC power connection to the PSM.
c.
d. If the green LED continues to remain off, contact Enterasys Networks. Refer to
4. If installing two PSM power supplies, repeat steps 1 through 3 for the second PSM.
Figure 2-3
Figure 2-4
1 Redundant Power Supply connector
2-6 Installation
2‐5.
2‐4, then plug the AC power cord into the main AC power outlet.
Check the AC power cord connection at the AC power source and make sure the
power source is within specification.
Swap the AC power cord with a known good one.
"Getting Help" on page 1‐5 for instructions. Otherwise, proceed to step 4.

C2RPS-PSM Cable

Power Connectors on C2RPS-PSM (rear view)
À
Power Cords
2‐3) to the Redundant
Á
2 AC power connector (rear of chassis)
2‐4 and