Installing C2Rps-Psms; Contents Of C2Rps-Chas2 Carton; Contents Of C2Rps-Psm Carton - Enterasys SecureStack C2RPS-CHAS2 Installation Manual

Installing C2RPS-PSMs

3. Perform a visual inspection of the switch devices for any signs of physical damage.
Contact Enterasys Networks if there are any signs of damage. Refer to "Getting Help"
on page 1‐5 for details.
Table 2-1 Contents of C2RPS-CHAS2 Carton
Item
C2RPS-CHAS2
This guide, SecureStack C2 Installation Guide (9034091-xx)
Release Notes
Table 2-2 Contents of C2RPS-PSM Carton
Item
C2RPS-PSM 150 Watt DC Power Supply Module
USA, NEMA Power Cord
C2RPS-PSM Cable
Notice Card
Installing C2RPS-PSMs
When you receive your C2RPS‐CHAS2 chassis, a coverplate will be in place over each
power‐supply slot.
To install the PSMs, refer to Figure
1. Place the chassis on a sturdy flat surface where you plan to install PSM
2. Align the PSM with one of the slots, then slide the PSM forward until its front panel is
flush against the chassis front panel.
3. Fasten the PSM to the chassis using the captive screws on the PSM front panel.
4. Repeat steps 2 and 3 for each additional PSM.
5. Proceed to "Installing C2RPS‐CHAS2 into the Rack" on page 2‐4 for the rack mount
installation instructions.
2-2 Installation
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
2‐1 and proceed as follows:
Quantity
1
1
1
Quantity
1
1
1
1
s
.