PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications
8.10.17 CF_P-MANETIME Command
Command
"CF_P-MANETIME_%1"[CR]
"01" ~ "30" ----------------------- Directly select setting time by the minute
"UP" ------------------------------- Plus one minute (01 → 02 → ÿ e ÿ e ÿ e → 30 → 01)
ÿ ÿ
"DN" ------------------------------- Minus one minute(30 → 29 → ÿ e ÿ e ÿ e → 01 → 30)
Set Power Management time
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.18 CF_ON-STA Command
Command
"CF_ONÿ STA_%1"[CR]
"ON" --------------------------- Set Direct on active
"OFF" ------------------------- Set Direct on inactive
"UP" --------------------------- Switch setting (On → Off → On → ÿ e ÿ e ÿ e )
%1
"DN" --------------------------- Switch setting (On → Off → On → ÿ e ÿ e ÿ e )
Note) "UP" and "DN" behave the same.
Set/Cancel Power ON Start
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.19 CF_PTIMEMODE Command
Command
"CF_PTIMEMODE_%1"[CR]
"COUNTUP" ---------------- Select Count up
%1
"COUNTDN" ---------------- Select Countdown
Set operation mode of P-timer.
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.20 CF_PTIMER Command
Command
"CF_PTOMER_%1"[CR]
"START" ----------------------- Execute P-timer
"STOP" ------------------------ Pause P-timer
%1
"RESTART" ------------------ Restart P-timer
"RST" -------------------------- Reset P-timer
"EXIT" -------------------------- Terminate P-timer function
Control P-timer.
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
39/72