Screen Control Command; Cf_Screen Command; Cf_Dzcent Command - Sanyo PLC-WL2500A Manual

PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications
8.7

Screen Control Command

8.7.1

CF_SCREEN Command

Command "CF_SCREEN_%1"[CR]
%1
Select image size on screen.
When Input specified by %1 is inappropriate for selected Input, the projector
returns "101" [CR] and the command is not executed.
Details "DZOOM UP" and "DZOOM DN" start effecting from the first command.
This command is available in normal Power ON status.
Note) When Input is computer and AV sorts signals (480i / 575i...etc) are entered,
the signal recognized as Video Input.
Acceptable
Response
Unacceptable
8.7.2

CF_DZCENT Command

Command "CF_DZCENT_%1"[CR]
%1 "CENT" ---- Cancel Digital Zoom (CENT: "CENTER")
Cancel Digital Zoom
When image is expanded or shrunk, reset its value.
Details
This command is available in normal Power ON status and when Input is
Computer.
Acceptable
Response
Unacceptable
"NORMAL" --------------------- Select Normal size
"TRUE" -------------------------- Select True size
"FULL" --------------------------- Select Full screen size
"CUSTOM" --------------------- Select Custom size
Input is "DZOOM_UP" ---------------- Expand image size with Digital Zoom
Computer "DZOOM_DN" ---------------- Reduce image size with Digital Zoom
"UP" ------------------------ Switch selectable screen size forward
"DN" ------------------------ Switch selectable screen size backward
"NORMAL" ---------------------- Select Normal mode
"ZOOM" --------------------------- Select Zoom mode
"NATURAL" ---------------------- Select Natural wide mode
"FULL" --------------------------- Select Full mode
"CUSTOM" ---------------------- Select Custom size
Input is
"UP" ------------------------ Switch selectable screen size forward
Video
(Normal → Full → Zoom → Wide → Natural → Custom →
Normal...)
"DN" ------------------------ Switch selectable screen size backward
(Custom → Natural → Wide → Zoom → Full → Normal →
Custom...)
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
28/72
(Normal → True →Full → Custom → Normal)
(Normal →Custom → Full→ True → Normal)