Cf_System Command - Sanyo PLC-WL2500A Manual

PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications
8.6.9

CF_SYSTEM Command

Command "CF_SYSTEM_%1"[CR]
Input is HDMI
%1
Select System of currently selected Input
When Input specified by %1 is inappropriate for selected Input, the projector
returns "101"[CR] and the command is not executed
This command is available in normal Power ON status.
Details Note1) "NTSC" / "NTSC4.43" / "PAL" / "SECAM" / "PAL-M" / "PAL-N" is available
Note2) "1080I" / "1035I" / "720P" / "575P" / "480P" / "575I" / "480I" is available only
Note3) D-XGA1/.../D-480P is available only when Input is applicable.
Acceptable
Response
Unacceptable
"VGA1" ------------- Select VGA1
:
"XGA1" ------------- Select XGA1
:
"WXGA3" ------------ Select WXGA3
"1080I" --------------- Select 1080I
Input is
"1035I" --------------- Select 1035I
Computer
"720P" ---------------- Select 720P
"575P" ---------------- Select 575P
"480P" ---------------- Select 480P
"575I" ----------------- Select 575I
"480I" ----------------- Select 480I
"MODE1"~ "MODE10"------------- Select Mode 1~Mode 10
"D-XGA1" --------------- Select D-XGA1
:
:
"D-WXGA3" ------------- Select D-WXGA3
"D-1080I" ---------------- Select D-1080I
"D-1035I" ---------------- Select D-1035I
"D-720P" ---------------- Select D-720P
"D-575P" ---------------- Select D-575P
"D-480P" ---------------- Select D-480P
Projector returns "101" when no signal is detected.
"AUTO" -------------------------- Select System "Auto"
"NTSC" -------------------------- Select NTSC
"NTSC443" --------------------- Select NTSC4.43
"PAL" ----------------------------- Select PAL
"SECAM" ----------------------- Select SECAM
"PAL-M" ------------------------- Select PAL-M
Input is "PAL-N" ------------------------- Select PAL-N
Video "1080I" -------------------------- Select 1080i
"1035I" -------------------------- Select 1035i
"720P" --------------------------- Select 720p
"575P" --------------------------- Select 575p
"480P" --------------------------- Select 480p
"575I" ---------------------------- Select 575i
"480I" ---------------------------- Select 480i
only when Input is VIDEO / S-VIDEO
when Input is Y / Pb/Cb / Pr/Cr
"000"[CR]
"Error Code"[CR]
27/72