Cr_Syslist Command; Cr_Modelist Command - Sanyo PLC-WL2500A Manual

PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications
9.7.9

CR_SYSLIST Command

Command "CR_SYSLIST"[CR]
Details Get selectable System titles
Acceptable
Response
Unacceptable

9.7.10 CR_MODELIST Command

Command "CR_MODELIST"[CR]
Details Get selectable Mode titles
Acceptable
Response
Unacceptable
"000_%1_%2_..._%x" [CR]
- When Input is PC-Analog
"XGA1" ------------ XGA1is selectable
"1080I " ----------- 1080i is selectable
Projector does not return Auto, Mode 1-10
When there is no signal, it returns Error Code "101"
- When Input is HDMI
"D-XGA" ---------- D- XGA1is selectable
"D-720P" --------- D-720P is selectable
When there is no signal, projector returns Error Code "101"
-When Input is Y,Pb/Cb,Pr/Cr
Returns all the System titles on Menu including Auto
"AUTO" ------------ Auto is selectable
"1080I" ------------ 1080i is selectable
"1035I" ------------ 1035i is selectable
ÿ
%1 ÿ
"575I" ------------ 575i is selectable
"480I" ------------ 480i is selectable
Projector does not return Error Code "101" even if there is no
signal.
-When Input is Video, S-Video
Returns all the System titles on Menu including Auto
"AUTO" ---------Auto is selectable
"PAL" ------------ PAL is selectable
"SECAM" ------ SECAM is selectable
ÿ
ÿ
"PAL-N" --------- SECAM is selectable
Projector does not return Error Code "101" even if there is no
signal.
""Error Code"[CR]
"000_%1_%2_..._%x" [CR]
Returns Error code "101" when Input is other than PC-Analog
Returns Error code "101" when Input is PC-Analog but no signal
When Input is PC-Analog and signal is found, returns selectable
%1
Mode among Mode1 – 10
%2
:
"MODE1"
%x
:
:
"MODE10
"Error Code"[CR]
56/72