Clock And Timer - GE JKP18 Owner's Manual

Usingthe clock and timer.
Make sure the clock is set to the
correct time of da_
ToSet the Clock
The clock must be set to the conect time
of day fin" tile m_tomatic oven tinting
tractions to work properly. Tile time of
day cannot be changed during a timed
baking or sell-cleaning {ycle.
[]
Press tile CLOCK pad.
[] Press tile number pads.
[] Press tlle START pad.
KITCHEN []
TIME
Ttie t#ner is a mflTutet#ner onl_
Ttie timer does not control oven
operations. Ttie maximum setting on
ttie timer is 9 hours and 59 mhTutes.
To Set the Timer
[]
[]
Press the KITCHEN TIMERON/OFF
pad.
Press the number pads until tile
atllotln[ of tiitle rot] wan[ shows ill
the displ W. For example, to set 2
hours and 4,5minutes, press 2, 4 and
5 in that order. Ify{)u make a mistake
press tile KITCHEN TIMERON/OFF
pad and begin again.
Press the STARTpad.
When tile timer reaches .'/70,
tile conuol will beep 3 times
followed by one beep eveU 6
secondsuntil tile KITCHEN TIMER
ON/OFF pad is pressed.
The 6 second tone can be canceled by
fi)llowing tile steps in the Special features
of your oven control section under Tones at
the End of a Timed Cycle.
NOTE: Onsomemodelsthetimecountsdown
/?nmedlate/y whentheSTART padispressedThe
tYnerisactuallycounting downin seconds that
arenotshownon thedisplay until thelastminute.
To Reset the Timer
If the display is still showing tile time
remaining, you may change it by pressing
the KITCHEN TIMER
ON/OFF
pad, then
press the number pads until the time you
want appears in the display.
If the remaining time is not in tile display
(clock, delay start or cooking time are in
tile display), recall tile remaining time by
pressing tile KITCHEN TIMERON/OFF pad
and then pressing tile number pads u)
enter tile new time you want.
ToCancel the Timer
Presstile KITCHENTIMERON/OFF
pad t_d(e.
12