Clock And Timer - GE JRP20 Owner's Manual

Clock and Timer

To Set the Clock
The clock must be set to the correct time of day for the
automatic oven timing functions to work properly. The
time of day cannot be changed during a delayed cooking
or a delayed self-cleaning cycle.
1. Touch the TIMER/CLOCK pad twice.
2. Touch the + or – pad.
you touch the TIMER/CLOCK pad, the display reverts
CLOCK pad twice and reenter the time of day.
To Turn Off the Clock Display
to turn off the time of day clock display on your oven.
1. Touch the TIMER/CLOCK pad once to turn off the
time of day display. Although you will not be able to
see it, the clock maintains the correct time of day.
2. Touch the TIMER/CLOCK pad twice to recall the
clock display.
To Set the Timer
The timer does not control oven operations. The
maximum setting on the timer is 9 hours and 59 minutes.
1. Touch the TIMER/CLOCK pad.
2. Touch the + or – pad until the amount of time you
want shows in the display. The maximum time that
can be entered in minutes is 59. Times more than 59
minutes should be changed to hours and minutes.
To Reset the Timer
may change it by touching the TIMER/CLOCK pad, then
touching the + or – pad until the time you want appears
in the display.
To Cancel the Timer
Touch the TIMER/CLOCK pad twice.
49-80715 Rev. 1
3. Touch the START pad until the time of day shows in
the display. This enters the time and starts the clock.
To check the time of day when the display is showing
other information, simply touch the CLOCK pad. The
time of day shows until another pad is touched.
TIMER/
and begin again.
3. Touch the START pad. The time will start counting
down, although the display does not change until one
minute has passed.
times followed by one beep every 6 seconds until the
TIMER/CLOCK pad is touched.
time or cooking time are in the display), recall the
remaining time by touching the TIMER/CLOCK pad and
then touching the + or – pad to enter the new time you
want.
TIMER/CLOCK pad
7