Download  Print this page

Hints For Test Institutes; Installation - Electrolux EDC78550W User Manual

Hide thumbs

Advertisement

Table of Contents
16 electrolux
Water hardness
Water contains, a variable
quantity of limestone and min-
eral salts of which quantities
vary according to geographical
locations thus varying its con-
ductivity values.
Relevant variations of the con-
ductivity of the water compared
to those prefixed by the factory
could slightly influence the re-
sidual humidity of the laundry at
the end of the cycle. Your dryer
allows you to regulate the sen-
sitivity of the drying sensor
based on conductivity values of
the water.

Hints for test institutes

Parameters possible to checked by the Test
Institutes:
• Energy consumption (corrected with final
humidity) during the cupboard dry cotton
cycle with nominal load.
• Energy consumption (corrected with final
humidity) during the cupboard dry cotton
cycle with half load.
• Final humidity (during cupboard dry cot-
ton, iron dry cotton and cupboard dry easy
care)

Installation

Important! The appliance must be moved in
vertical position for transport.
Appliance positioning
• It is recommended that, for your conven-
ience, the machine is positioned close to
your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all round
the appliance. Do not obstruct the front
ventilation grille or the air intake grilles at
the back of the machine.
• To keep vibration and noise to a minimum
when the dryer is in use, it should be
placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or
lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through deep-
1. Turn the programme selector to any programme.
2. Press simultaneously the Droogtegraad and START/PAUZE
buttons and hold down for approx. 5 seconds. The current set-
ting is on the display:
low conductivity <300 micro S/cm
medium conductivity 300-600 micro S/cm
high conductivity >600 micro S/cm
3. Press the START/PAUZE START PAUZE button sequentially
until you set desired level.
4. To memorize setting press simultaneously the the Droogte-
graad and START/PAUZE buttons or turn knob to O off po-
sition
• Condensation efficiency (corrected with fi-
All the cycles have to be checked in accord-
ance with EN 61121 (Tumble dryers for
household use – Methods for measuring the
performance).
Important!
The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The ap-
pliance must therefore not be installed on
floors which are not resistant to high temper-
atures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Important! Should the appliance be moved,
it must be transported vertically.
Important! The appliance must not be
installed behind the lockable door, a sliding
door a door with a hinge on the opposite side
to that of the appliance.
nal humidity) during cupboard dry cotton
cycle with nominal and half load
pile carpets, strips of wood or similar. This
might cause heat built-up which would in-
terfere with the operation of the appliance.

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Electrolux EDC78550W