Advertisement
9.3 Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
Alternatively:
1. Rotate the selector knob to the
position.
2. Wait for 1 second. The display shows
.
3. Set the programme.
9.4 At the end of the programme
When the programme is completed:
• An intermittent acoustic signal operates.
• The display shows
• The indicators
comes on.
• The Start/Pause indicator is on.
The appliance continues to operate with the
anti-crease phase for approximately 30
minutes or more if Long Anticrease option
was set (see chapter
Anticrease ).
The anti-crease phase reduces creasing.
You can remove the laundry before the anti-
crease phase is completed. We recommend,
for better results, that you remove the laundry
when the phase is almost completed or
completed.
When the anti-crease phase is completed:
• The display still shows
• The indicators
comes on.
10. HINTS AND TIPS
10.1 Preparing the laundry
Loading the drum up to the maximum
capacity indicated for the respective
programmes will contribute to the energy
saving.
16
ENGLISH
"Reset"
Filter and
Tank
Option - Long
Filter and
Tank
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
Adjustment of default dryness
See chapter
level
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
Always clean the filter and empty the
water container when a programme is
completed.
9.5 Low power mode
To reduce energy consumption, this function
automatically deactivates the appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme.
When the appliance goes in low power
mode you can reactivate it by pressing
on/off button.
The time is reduced to 30 seconds if the
selector knob is pointing to
position.
"Reset"
Advertisement
