Hints And Tips - Electrolux TWL5E500 User Manual

program dial (this option does not lock the
On/Off (Ein/Aus) button).
You can activate the child lock option:
• before you touch the Start/Pause button -
the appliance cannot start
• after you touch the Start/Pause button -
programs and option selection is
unavailable.
Child lock option activation:
1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down Anticrease
(Knitterschutz) button by around 3
seconds.
The symbol appears on the display.
4. To deactivate the child lock, touch the
above button again until the symbol
disappears.
8.8 Starting a program
To start the program:
Touch the Start/Pause button.
The appliance starts and the LED above the
button stops flashing and stays on.

9. HINTS AND TIPS

9.1 Ecological hints
• Spin the laundry well before drying.
8.9 Program change
To change a program:
1. Push the On/Off (Ein/Aus) button to turn
the appliance off.
2. Push the On/Off (Ein/Aus) button again to
turn on the appliance.
3. Set a new program.
8.10 Programme end
Clean the filter and drain the water
container after each drying cycle. (See
chapter CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Buzzer option is
activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the appliance, the
anti-crease phase starts (not active with
all programmes). Flashing
signals the execution of the anti-crease
phase. Laundry can be removed during
this phase.
To remove the laundry:
1. Push the On/Off (Ein/Aus) button for 2
seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
Adjustment of default dryness
See chapter
level
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
• Do not exceed the load sizes which are
specified in the programmes chapter.
symbol
ENGLISH 17