Table of Contents
Advertisement
22 electrolux
9. Gently lift and carefully take off the up-
permost pane
1
10
Repeat the procedure described in point
.
9. for the middle pane marked by a dec-
orative frame on 4 sides
1
Clean the oven door with lukewarm water
and a soft cloth. Do not use products such
as scouring pads, steel wool, abrasive
sponges or acids because they could dam-
age the special heat-reflecting surface of the
internal panes of glass.
After cleaning, reassemble the panes in the
door and then the oven door, following the
procedure described above in reverse. Make
sure you reposition the panes correctly.
To perform this operation correctly, proceed
as follows:
1. the decorated middle pane with a frame
on the 4 sides must be reassembled so
that the screen-printing is facing out-
wards. The side of the pane of glass is
correct if you do not feel any roughness
near the screen printing when you pass
your fingers over the surface.
The middle pane of glass must be put
back into the right seats as shown
2
2. the uppermost pane must be reassem-
2
After the panes of glass have been reassem-
bled in the oven door, perform the procedure
described in point 8. in reverse to ensure they
are locked.
Important! Never clean the oven door
when it is warm as the panels might
shatter. If you can see scratches or
cracks in the glass panel, call your
nearest service centre immediately to
have the panel replaced.
Replacing the oven light
Important! Separate the appliance from the
power supply by switching off the fuse.
If the oven bulb needs replacing, the new
bulb must have the following specifications:
– Electric power: 40 W
– Electrical rating: 230 V (50 Hz)
– Heat resistance up to 300 °C
– Connection type: E14
These replacement bulbs can be purchased
from your dealer.
To change the oven light:
bled as shown
Advertisement
Table of Contents
