Table of Contents
Advertisement
10 electrolux
will flash and the control panel will
display «0.00»
3. While the symbol
control "
" to select the required time.
The maximum time is 23 hours 59 mi-
nutes. The programmer will wait 3 sec-
onds and then start running.
4. After the time programmed elapses, the
oven switches off automatically. An
acoustic alarm sounds and the display
shows "0.00" .
5. To switch off the acoustic alarm, touch
any control..
To cancel the programmed cooking
time:
1. Touch control
flashes.
2. Touch control "
until the display shows "0.00"
To programme the oven to switch on
and off
1. Carry out the "Cooking time" setting as
described in the relevant chapter.
2. Touch control
ing» function
evant symbol flashes. The control panel
will display the end of cooking time (that
is, the actual time + Cooking time)
is flashing, touch
, until the symbol
" to decrease the time
until the «End of Cook-
is selected and the rel-
3. Touch control "
end of cooking time.
4. Once the setting is made, the program-
mer waits 3 seconds and then starts run-
ning.
5. The oven switches on and off automati-
cally. An acoustic signal sounds.
6. To switch off the acoustic signal, touch
any control.
To cancel the programme, simply cancel
the Cooking Time.
Special functions
Oven safety switch-off
The oven will switch off automatically if any
change of setting is made, according to the
following table
Temperature set-
ting:
250ºC
from 200 up to 245°C
from 120 up to 195°C
less than 120°C
Residual heating function
When a cooking time is set, the oven will au-
tomatically switch off a few minutes before
the end of the programmed time, and use the
residual heat to finish your dishes without en-
ergy consumption.
All current settings will be displayed until the
cooking time is over.
This function will not operate when the cook-
ing time is less than 15 minutes.
" to select the required
the oven will switch
off:
after 3 hours
after 5.5 hours
after 8.5 hours
after 12 hours
Advertisement
Table of Contents
