Emerson Botanica CF2500HTW01 Owner's Manual page 7

WARNING
!
The fan must be hung with at least 7' of clearance
from floor to blades (Figure 12).
AT LEAST
7'
Figure 12
WARNING
!
The outlet box must be securely anchored and capable
of withstanding a load of at least 50 lbs.
18. Securely attach the hanger bracket to the outlet
box using the two screws supplied with the outlet
box (Figure 13).
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked acceptable for
fan support, and use screws supplied with outlet
box. Most outlet boxes commonly used for support
of light fixtures are not acceptable for fan support
and may need to be replaced. Consult a qualified
electrician if in doubt.
WARNING
!
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
Figure 13
19. Carefully lift the fan and seat the hanger
ball/downrod assembly on the hanger bracket
that was just attached to the outlet box (Figure
14). Be sure the groove in the ball is lined up with
tab on the hanger bracket (Figure 13).
WARNING
!
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
CEILING
FLOOR
OUTLET
BOX
HANGER
BRACKET
TAB
NOTE: CEILING COVER,
SUPPLY WIRES AND
FAN WIRES OMITTED
FOR CLARITY.
Figure 14
!
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and the
hanger bracket.
20. Position the receiver (supplied with the SW330
Remote Control or SW350 Wall Control) by
passing the opening in the receiver over the
downrod (Figure 15).
HANGER
BRACKET
1/8" FOAM
SW375
ADHESIVE
RECEIVER
PAD
Figure 15
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is ground-
ed, contact a licensed electrician for advice, as it
must be grounded for safe operation.
21. Connect the black wire from the wiring harness to
the black (hot) supply wire (Figure 4). Connect the
white wire from the wiring harness to the white
(neutral) supply wiring. Connect the green ground
wires from the hanger bracket and the hanger ball
to the supply ground wire. Use wire connectors
supplied with your ceiling fan.
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
7
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
WARNING
HANGER
BALL
OPEN
SIDE
FLAT SIDE
CEILING
COVER
WARNING
WARNING