Using The Front Panel Keypad - Hitachi L100 Series Instruction Manual

Using the Front Panel Keypad

Front Panel Introduction
Please take a moment to familiarize yourself with the keypad layout shown in the figure
below. These are the visible controls and indicators when the front panel door is closed.
Parameter Display
Run/Stop LED
Program/Monitor LED
Run Key Enable LED
The display is used in programming the inverter's parameters, as well as monitoring
specific parameter values during operation. Many functions are applicable only during
the initial installation, while others are more useful for maintenance or monitoring.
Parameter Editing Controls
Now, open the front panel (half-door) for
second-level access to reveal additional operator
keys for parameter editing as shown to the right.
In normal operation after installation, parameter
editing is unnecessary, so these controls are
hidden from view. The front panel controls and
indicators are described as follows:
• Run/Stop LED - ON when the inverter output
is ON and the motor is developing torque
(Run Mode), and OFF when the inverter
output is OFF (Stop Mode).
• Program/Monitor LED - This LED is ON
when the inverter is ready for parameter editing (Program Mode). It is OFF when the
parameter display is monitoring data (Monitor Mode).
• Run Key Enable LED - is ON when the inverter is ready to respond to the Run key,
OFF when the Run key is disabled.
• Run Key - Press this key to run the motor (the Run Enable LED must be ON first).
Parameter F_04, Keypad Run Key Routing, determines whether the Run key generates
a Run FWD or Run REV command.
• Stop/Reset Key - Press this key to stop the motor when it is running (uses the
programmed deceleration rate). This key will also reset an alarm that has tripped.
• Potentiometer - Allows an operator to directly set the motor speed when the potenti-
ometer is enabled for output frequency control.
• Potentiometer Enable LED - ON when the potentiometer is enabled for value entry.
HITACHI
5 0.0
RUN
PRG
STOP
RUN
RESET
Run Key Stop/Reset Key
L100 Inverter
Power LED
POWER
Display Units
Hz
Hertz / Amperes LEDs
A
Potentiometer Enable LED
MAX
MIN
Potentiometer
HITACHI
RUN
PRG
RUN
FUNC.
Function
Up/Down
Key
Keys
2–21
POWER
5 0.0
Hz
A
STOP
RESET
MIN MAX
2
STR
1
Store
Key