EUROCOM 5100-S DeskNote Lite User Manual page 86

Table of Contents

Advertisement

Suspend to Disk
Suspend to Disk uses no power and saves all of your information
on a part of the HDD. It saves the maximum power but takes the
longest time to return to full operation. You can set your note-
book to automatically enter Suspend to Disk mode when the
battery power is almost depleted. This prevents losing any data
due to loss of power. To set this feature, go to the SCU Power
Menu and choose Enable Battery Low Suspend.
In order to use Suspend to Disk, you must partition your Hard
Disk Drive, the instructions are as follows:
1: Use your operating system's FDISK program to delete all
hard disk partitions if any already exist on the target drive.
2: Boot the system and run the 0VMAKFIL.EXE Utility to
create the Suspend to Disk partition on the hard disk. The
size of the Suspend to Disk partition will be the installed
DRAM (n) plus 8 MB integrated video RAM.
For example, if the system DRAM is 32 MB, 0VMAKFIL
will create a partition size of approximately 40 MB.
Resume from Suspend to Disk Mode
The system will resume from Suspend-to-Disk mode by:
Pressing the power button.
Alarm resume (month/day/hour/minute)
:\>0VMAKFIL -Pn
:\>0VMAKFIL -P32
Chapter 5: BIOS Utilities
5-21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5100-S DeskNote Lite and is the answer not in the manual?

This manual is also suitable for:

Desknote lite 5100-se

Table of Contents