Ink Cartridges Cartridge Part number Black S020189 Color S020191 Media Media name Size EPSON 360 dpi Ink Jet Paper Letter EPSON High Quality Ink Jet Letter Paper EPSON Photo Quality Ink Jet Letter Paper Legal EPSON Photo Quality Glossy Letter...
Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper. Always test samples of paper stock before purchasing large quantities or printing large jobs.
* The figure given is based on continuous printing after ink replacement. The actual print capacity may vary, depending on how often you turn on the printer and how often you clean the print head. ** Ink thaws and is usable after approximately 3 hours at 77 °F (25 °C).
Then turn off the printer, wait a few seconds, and turn it on again. If the lights still flash, contact your dealer or EPSON. When all the lights are off, the printer is not receiving power. Try these solutions: Make sure the printer is turned on.
9.) 5. To end the check, turn off the printer after it prints the check page. Then reconnect the interface cable and turn on your printer and computer.
(The EPSON Stylus COLOR 760 has a solid color cover.) Replacing an Ink Cartridge When the B black or A color ink out light flashes, the indicated cartridge is low on ink. This is a good time to make sure you have a new cartridge.
You can replace a cartridge when the B black or A color ink out light is either flashing or on. (If you perform these steps when both ink out lights are off, the printer cleans the print heads as described on page 9.) Be sure you have a new ink cartridge before you begin.
Follow these steps to replace an ink cartridge before the B black or A color ink out light is flashing or on: 1. Make sure the printer is turned on and not printing (the P power light should be on, but not flashing), then open the printer cover.
9 When you don’t turn on your printer for a long time, the print quality can decline. It’s a good idea to turn on your printer at least once a month to maintain good print quality.
Load paper that’s at least 8.27 inches (210 mm) wide to prevent ink from spraying inside the printer and smudging your printouts. For the best results, load EPSON ink jet paper in the printer whenever you check the print head alignment. , point to...
Be sure to remove the tape used in step 4 after installing the printer in its new location. 1. Turn on the printer, wait until the print head locks in the far right position, then turn off the printer. 2. Unplug the power cord from the electrical outlet. Then disconnect the printer cable from the printer.
EPSON Stylus COLOR 760 8/99 12 - EPSON Stylus COLOR 760...