Epson Stylus COLOR 760 Service Manual page 127

EPSON Stylus COLOR 760
3. Click the "Previous" and go back to the BI-Directional Adjustment"
menu. And select the "Adjust" menu and click the "OK" button.
Figure 5-26. Select the Adjust menu
4. Check the printed pattern and find the misaligned dot type.
5. Select the misaligned dot size in the following menu and click the
"OK" button.
Figure 5-27. Select the misalined dot size
Adjustment
6. By selecting the misalined dot size, following input menu for the
adjustment value is displayed.
Figure 5-28. Bi-d adjustment input menu
7. Check the printed pattern again and Input the suitable value in the
above menu and click the "OK" button. The input value is written in
the specific address of the EEPROM. Refer to Figure 5-29.
The value 0 (blue) appears in the center of the screen and changes
the value by clicking the up/down icon. Apply the value for the most
properly aligned pattern in the Bi-D adjustment pattern print.
You can change the value by input the suitable value directly from
the key board.
In case the + value is input, the 2nd vertical printed pattern is shift to
the left side. And in case the - value is input, the 2nd vertical printed
pattern is shift to the right side.
Adjustment
Revision C
127