Epson Stylus COLOR 760 Service Manual page 99

EPSON Stylus COLOR 760
7) Move the PG Lever to bring its hooks to the nothes of the cutouts in the
right side of the Top Frame. Then remove the PG Lever by releasing the
hooks. Refer to Figure 4-38.
Right of theTop Frame
Figure 4-38. Align the PG Lever with the Notches
8) Remove the Torsion Spring 63.7 hanging on the right side of the Top
Frame and PG lever with tweezers. Refer to Figure 4-38.
9) Release the fixed hook of the PG Lever Support and remove the PG Lever
Support and Disk Spring (6.2x0.15x1, S/NA) from the right edge of the CR
Guide Shaft. Refer to Figure 4-38.
Torsion Spring 63.7
Figure 4-39. Removing the Torsion Spring 63.7 & PG Lever
Disassembly and Assembly
PG Lever
Notch portion
No.7 Screw
Disk Spring
PG Lever Support
Disassembly Procedures
10) Remove one screw (No.7) and rotate the Right Parallelism Adjustment
Bushing and move it forward so that the locking protrusion of the Right
Parallelism Adjustment Bushing fits in the notches on the right side of the
Top Frame. Refer to Figure 4-40.
Right Parallelism
Adjustment Bushing
Figure 4-40. Removing the Right Parallelism Adjustment Bushing
Be careful when removing the Right Parallelism Adjustment
Bushing. If you remove it with the printhead installed, the CR
Unit will fall to the platen.
Revision C
Notches on the Top Frame
99