Adjustment Program Initial Setting Menu - Epson STYLUS COLOR 580 Service Manual

EPSON Stylus COLOR 580

5.1.4 Adjustment Program Initial Setting menu

You have to input the following four items before entering the adjustment main menu.
o
Model name (Stylus COLOR 580)
o
Interface setting (EPUSB1, EPUSB2, EPUSB3)
o
Market (World, ESP, EIO)
o
Program type (Individual service adjustment program or Sequential repair service
program)
Follow the procedure below to input the initial settings.
1. When you run this program, the following menu appears. Select the Stylus
COLOR 580 in the screen below.
Figure 5-3. Model Name Selection
NOTE: This printer stores model name in the PROM. Therefore, even you select
the model name in the screen above, model name will not stored in the
EEPROM. Selecting model name in the screen above determines
respective special command for each model.
2. Select the USB port number which you connect the printer to your PC as above
Figure 5-3.
Adjustment
3. Select the suitable destination in the market menu. "World" is the standard
destination setting except the ESP and EIO. The waste drain ink pad life for ESP &
EIO product is different from World standard. So, you have to select the suitable
destination in order to set the suitable waste drain ink pad life. This setting is used
when the waste drain ink pad counter is reset or the main board is replaced with
new one in the adjustment program.
Figure 5-4. Destination Setting
4. Select the Program type which you will run in the menu.
Figure 5-5. Program type selection.
Overview
Revision A
103