Epson STYLUS COLOR 580 Service Manual page 62

EPSON Stylus COLOR 580
Table 3-21. Paper is not ejected completely without any error indication
Paper is not ejected completely without any error indication
Step
Detail phenomenon
No.
1. Check if the Paper
eject roller rotate when
the paper is ejected.
Printing is normal.
But, the paper is not
ejected completely and
2. Check if the Paper
1
the bottom area stay
eject frame is secured
around the Paper eject
with the three fixing
frame.
screws to the Main
frame.
Troubleshooting
Check point Remedy
1. Assemble the Spur gear
15 to the protrusion on the
pump unit.
Spur gear 15
2. Secure the Paper eject
frame witt the two fixing
screws to the Main
frame.
Paper eject frame
Unit Level Troubleshooting
Table 3-22. Dot missing occur and it is not recovered with CL
Dot missing occur and it is not recovered with CL
Step
Detail phenomenon Check point
No.
1. Check if ink is ejected
to the waste ink pad via
pump unit in the CL
sequence.
2. Check if there is any
foreign material
around the seal rubber
parts on the cap
assembly.
In the CL sequence,
the pump unit seems
work correctly. But,
Cap seal rubber
ink is not ejected to the
waste ink pad at all.
1
3. Check if any damage
Moreover, any ink is
is observed around the
not absorbed from the
seal rubber parts on
head to the cap.
the cap assembly.
4. Check if the two
compression spring
are assembled in the
Cap assembly
correctly.
Compression
spring
Revision A
Remedy
1. If ink is not ejected at all
to the waste ink pad in the
.
CL sequence, proceed the
following check point 2).
2. Remove the foreign
material around the seal
rubber parts.
parts
3. Replace the Cap
assembly with new one.
4. Set the Compression
spring into the Cap
assembly.
62