Overview; Precautions - Epson STYLUS COLOR 580 Service Manual

EPSON Stylus COLOR 580

4.1 Overview

This section describes procedures for disassembling the main components of the Stylus
COLOR 580. Unless otherwise specified, disassembly units or components can be
reassembled by reversing the disassembly procedure. Things, if not strictly observed,
that could result in injury or loss of life are described under the heading "Warning".
Precautions for any disassembly or assembly procedures are described under the
heading "CAUTION". Chips for disassembling procedures are described under the
heading "CHECK POINT".
If the assembling procedure is different from the reversed procedure of the
disassembling, the procedure is described under the heading "REASSEMBLY".
Any adjustments required after disassembling the units are described under the heading
"ADJUSTMENT REQUIRED". When you have to remove any units or parts that are
not described in this chapter, refer to the exploded diagrams in the appendix.
Read precautions described in the next section before starting.
Disassembly and Assembly

4.1.1 Precautions

See the precautions given under the handling "WARNING" and "CAUTION" in the
following column when disassembling or assembling EPSON Stylus COLOR 580.
n
Disconnect the power cable before disassembling or assembling
the printer.
n
Wear protective goggles to protect your eyes from ink. If ink gets
in your eye, flush the eye with fresh water and see a doctor
immediately.
n
If ink comes into contact with your skin, wash it off with soap and
water. If irritation occurs, contact a physician.
n
A lithium battery is installed on the main board of this printer. Be
sure to observe the following instructions when serving the
battery:
1.Keep the battery away from any metal or other batteries so that
electrodes of the opposite polarity do not come in contact with
each other.
2.Do not heat the battery or put it near fire.
3.Do not solder on any part of the battery. (Doing so may result in
leakage of electrolyte from the battery, burning or explosion.
The leakage may affect other devices close to the battery.)
4.Do not charge the battery. (An explosion may be generated inside
the battery, and cause burning or explosion.)
5.Do not dismantle the battery. (The gas inside the battery may hurt
your throat. Leakage, burning or explosion may also be
resulted.)
6.Do not install the battery in the wrong direction. (This may cause
burning or explosion.)
n
Danger of explosion if the battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacture. Dispose the used batteries according to
government's law and regulations.
Overview
Revision A
67