Epson STYLUS COLOR 580 Service Manual page 113

EPSON Stylus COLOR 580
4. If the EEPROM is normal condition, following message is displayed. Click the
"OK" button to start the EEPROM back up function.
Figure 5-34. Start EEPROM back up function
In case the following message is displayed, the EEPROM back up function is
disable. Click the "OK" button to proceed the Step 9) to input the necessary data to
the new main board manually.
Figure 5-35. EEPROM is defective.
5. When the EEPROM back up is completed, following message is displayed.
Replace the defective main board with new one by following the message and
click the "OK" button after the replace the Main board.
Figure 5-36. Replace the defective main board with new one
Adjustment
6. Turn on the printer and click the "Load on EEPROM "to copy the EEPROM back
up data to the new main board. It takes about 30 seconds to complete the
EEPROM data copy.
Figure 5-37. Copy the EEPROM data to the new main board.
7. When the EEPROM back up data is copied successfully, following message is
displayed and the necessary service items for Main board replacement is
completed.
Click the "Menu" button to exit this program.
8. Click the "Get status" and check the Waste drain ink pad counter in this function.
If the waste drain ink pad counter is around the limit counter, replace the pad and
reset the counter according to the customer request.
Sequential Repair Service Program feature
Figure 5-38. EEPROM back up data copy succeed
Revision A
113