Table of Contents
Advertisement
See that the ON LINE and READY lights are on. (Be sure that you
1.
do not touch the power switch and cancel all the modes.)
2. Press the
ON LINE
Press the
3.
ON LINE
sized.) Notice that the ON LINE light is blinking and that it is on
more than it is off. This tells you that the emphasized mode is set.
Press the
4.
FF
but it is off more than it is on. This tells you that the emphasized
mode is cancelled.
5. Press the
LF
Press the
6.
ON LINE
Now you have cancelled emphasized without affecting any other
modes.
Some users think that this procedure is too complicated and prefer
to cancel all the SelecType settings and then reset the ones they want.
Use whichever method you prefer. If you want to cancel modes indi-
vidually, remember to watch the ON LINE light. It blinks mainly on
when a mode is set and mainly off when it is not.
Troubleshooting
If the printer freezes and a program will not run, try turning off
both the computer and the printer, then turn the printer on first and
the computer on second before you try the program again.
If you're printing labels and a self-adhesive label comes off of the
backing, it may stick behind the platen and cause problems with paper
feeding and irregular darkness of printing. If this happens, take your
to a qualified service person; do not attempt to remove the label
LX-90
yourself.
Beeper Error Warnings
When the
LX-90's
is out of paper. The beeper can also be sounded by certain error condi-
tions in the printer itself.
and
buttons to enter SelecType.
FF
button twice. (This is the code for empha-
button once. Now the ON LINE light is still blinking,
button once to leave SelecType mode.
button to put the printer on-line.
beeper sounds, it usually indicates that the printer
E-3
Advertisement
Table of Contents
