Table of Contents
Advertisement
Always turn the power OFF (with the switch on the right side of the
printer) before you change the setting of any of these switches. Any
changes made while the power is on will be ignored until you turn the
printer off and back on. So set all switches with the power off.
Table D-l shows you the functions of all the switches, and the rest
of the appendix explains each of them.
No. ON
1-1 Compressed
1-2 NLQ
1-3
Active
1-4 12 inches
l-5 Inactive
1-6 Alternate
1-7
l-8
No. ON
2-1
0 (slashed)
2-2
2-3 CR + LF
2-4 Mute
Note: The factory setting of all these switches is OFF.
Switch 1-1 selects pica or condensed printing. ON is condensed; OFF
is pica. Regardless of the setting, you can still select condensed with
SelecType and either condensed or pica with ESCape codes.
Switch 7-2 selects draft or Near Letter Quality. When it is ON, the
printer prints in the NLQ mode. When it is OFF, it prints in the draft
mode. If the switch is off, you can still select the NLQ mode with
SelecType or an ESCape code.
Switch 1-3 controls the optional cut-sheet feeder. When it is ON, the
cut-sheet feeder is enabled. When it is OFF, the cut-sheet feeder is dis-
abled.
selects the paper length. When it is OFF, the length is 11";
Switch
7-4
when it is ON, the length is 12".
D-2
Table D-l. DIP switch functions
Switch 1
Function
Print mode
Print mode
Cut-sheet feeder
Page length
Paper end detector
Character set selection
Baud rate selection
See Table D-2
Switch 2
Function
Zero character
Not used
(Automatic line feed
Beeper
OFF
Pica
Draft
I Inactive
11 inches
Active
Standard
OFF
0
CR only
Active
I
I
Advertisement
Table of Contents
