Power Board Removal - Epson EPL-5700 Service Manual

EPL-5700

4.2.19 Power Board Removal

1. Remove the right cover. (See section 4.2.2)
2. Remove the paper empty sensor. (See section 4.2.4)
3. Remove the control panel. (See section 4.2.6)
4. Remove the front cover.(See section 4.2.7)
5. Remove the shield cover of the main control board. (See section 4.2.9)
6. Remove the left cover.(See section 4.2.10)
7. Remove the top cover. (See section 4.2.14)
8. Remove the rear cover. (See section 4.2.15)
9. Remove the harness of the heater lamp from connector CN2 on the
power board. (Refer to section 4.2.16)
10. Remove the harness of the inter lock switch from connector CN3 on the
power board.
11. Remove the harness of the main control board from connector CN207 on
the main board.
12. Remove two CP(O) screws(3x6) and two CS screws(3x6) securing the
power board unit to the right and left frames of the printer, and remove
the power board unit.
Rev. A
Interlock
Switch Harness
CS(3x6)
Power Unit
Figure 4-33. Power Unit Removal
Chapter4 Disassembly and Assembly
Main Control Board
CP(O)(3x6)
4-24