Panel Operation; Power Switch; Control Panel; Switches - Epson EPL-5700 Service Manual

EPL-5700

1.3 PANEL OPERATION

1.3.1 Power Switch

Power switch is located left rear side of the printer. It controls power On/Off.

1.3.2 Control Panel

The control panel of EPL-5700 is located right edge of the front printer.
There are six LED lights and four non lock type switches.
Paper
Toner
Memory
Alt
Continue Form Feed On Line
Reset
Status Sheet
Figure 1-3. Control Panel
Rev. A

1.3.2.1 Switches

Y
On line switch: Switches the printer between on line and off line
status.
Y
Form feed switch: When the printer is off line and data remains in the
printer's memory, prints out the data and clears the
buffer. If used in combination with the Alt button, a
status sheet is printed.
Y
Continuous switch:Enables the printer to resume printing after certain
maintenance-required conditions or errors have been
cleared. If used in combination with the Alt button, the
printer is reset.
Y
Alternate switch: Use this button in combination with the Continue
button in order to stop printing and reset (Warm boot).
In the reset condition, if both Alt switch and Continue
switch are pressed more than 5 seconds, the printer
goes to "Reset All" condition.

1.3.2.2 Lights

Y
On Line LED(green): Displays a non-flashing light when the printer
is on line, indicating the printer can receive
print data. When the printer is off line, this light
is off. The light flashes as the system switches
between on-line and off-line status.
Y
Form Feed LED(yellow): Comes on when data is received and stored in
the printer's buffer prior to printing. Flashing
indicates the printer is processing data. When
no data remains in the printer buffer(the
section of memory reserved for receiving
data), this light is off.
Y
Continue LED(red): Flashes when an error is detected or a
maintenance procedure must be performed.
Y
Paper LED(yellow): Displays a non-flashing light when a general
paper error, or "Printer Open" error has
occurred.
Y
Toner LED(yellow): Displays a non-flashing light when it is time to
change the developer cartridge (toner).
Flashes to indicate the toner is low.
Chapter1 Product Description
1-8