Driving Unit Removal - Epson EPL-5700 Service Manual

EPL-5700

4.2.23 Driving Unit Removal

1. Remove the right cover. (See section. 4. 2.2)
2. Remove the paper empty sensor. (See section 4.2.4)
3. Remove the control panel. (See section 4.2.6)
4. Remove the front cover. (See section 4.2.7)
5. Remove the shield cover of the main control board. (See section 4.2.9)
6. Remove the left cover.(See section 4.2.10)
7. Remove the top cover. (See section 4.2.14)
8. Remove the rear cover. (See section 4.2.15)
9. Remove the fusing unit. (See section 4.2.16)
10. Remove the power unit. (See section 4.2.19)
11. Remove the screw for main motor. (See section 4.2.22)
12. Remove three CS screws(3x6), one paper feed fixing screw, two CSB
screws (3x8) and remove unit, securing the driving unit to the printer.
(Parts marked with )
13. Remove seven CSB screws(3x8) securing the driving unit to the left
frame.(Parts marked with )
Rev. A
Chapter4 Disassembly and Assembly
! :
CS(3x6)
CSB(3x8)
Fixing Screws
Left Frame
Figure 4-38. Left Frame Removal
CS(3x6)
CS(3x6)
CSB(3x8)
4-28