Front Cover Removal - Epson EPL-5700 Service Manual

EPL-5700

4.2.7 Front Cover Removal

1. Remove the right cover.(See section. 4.2.2)
2. Remove the control panel. (Refer to section.4.2.6)
3. Remove one CS screw(3x8) securing the front cover to the shield cover
of the main control board.
Upper Edge Hooks at Front Cover
Front Cover
Figure 4-11. Fixing Screws at the Front Cover
4. Release two lower edge hooks(one is located right bottom side, the other
is located left bottom) securing the front cover to the printer mechanism
by inserting the shaft of the driver from the holes, which are for installing
the optional second paper feed unit, and remove the front cover from the
bottom side.
Rev. A
Left Edge Hook
Figure 4-12. Lower Edge Hooks of the Front Cover
CHECK POINT
CS(3x8)
Chapter4 Disassembly and Assembly
Holes for installing
the second paper feed
unit
When installing the front cover to the printer, first,
hand the upper hooks of the front cover on the
mechanism, and install two lower hooks of the
cover to the mechanism.
Right Edge Hook
4-9