Idle Of The Cutter Bar When Shut Off - Duerkopp Adler 550-12-23 Service Instructions Manual

2.18.3 Idle of the Cutter Bar when Shut Off

3
With the edge cutter switched off the cutter bar should have minimal
movement. (An absolute idle is not possible)
Caution Risk of Injury!
Before adjusting turn the main switch off.
–
Loosen clamping screw 1 on the clamping piece 2.
–
Adjust the tension bar 3 so that the cutter bar has the smallest
possible movement when the handwheel is turned.
–
Tighten clamping screw 1 again.
2 1
39