Ringmod Mode - Native Instruments Absynth 5 Reference Manual

•
Phase control: Sets the phase of the Oscillator. The effect is only audible if a second
Oscillator is active. This parameter is useful when using integer values for frequency ratios
between carrier and modulator, as it is the case in FM.

5.4.6 Ringmod Mode

In Ringmod mode, the signals from the main oscillator and the mod oscillator are multiplied
with one another.
On the Main panel, you find the same parameters as in Single mode. For more details, please
refer to the section 5.4.3, "Single
On the Mod panel, the following parameters are available:
•
Balance control: Controls the balance between the oscillators Main and Mod within the
Oscillator's output signal.
•
Waveform Selector: Click on the Waveform Selector to open a dialog where you can choose
the Waveform for the oscillator (see section
Selection dialog", above for details).
•
Frequency menu and Frequency control: Enables you to enter the oscillator's frequency as
a transposition of the played note (Trans), as a relationship (Ratio) with the played note,
as a fixed Frequency (Hz) or via a fixed MIDI note (Note). See section
Menu and Frequency
Mode", above.
Control", above for details.
5.3.1, "Waveform Selector and Waveform
ABSYNTH 5 Reference Manual – 56
5.3.2, "Frequency