Replacing The Bearings Of The Steering System; Steering Headset Cups; Fork Cone - PEUGEOT Tweet Workshop Manual

STEERING/FORK
Replacing the bearings of the steering
system

Steering headset cups

If the steering head cups are changed,
the cones and ball bearings must also
be changed.
- Using a drift, remove the steering head cups.
- Using push tool P/N 755039, fit a new upper
cup into the steering tube.
- Using push tool P/N 759788, fit a lower cup
into the steering tube.

Fork cone

- Unscrew and remove the 2 upper screws (4)
from the fork Tee.
- Unscrew the 2 lower screws (5) from the fork
Tee.
- Remove the fork tubes.
- Remove the front mudguard (3 screw).
- Using a drift, remove the steering headset
cone.
- Remove the dust cover.
- Remove the washer.
46
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
759788
4
5