Miscellaneous Operations; Removal Of The Fork; Replacing The Bearings Of The Steering System - PEUGEOT Vivacity Workshop Manual

MISCELLANEOUS OPERATIONS

MISCELLANEOUS OPERATIONS

Removal of the fork

Replacing the bearings of the steering
system
- Remove the rear shield panel. See:
Procedure 4. page 19
- Remove the handlebars from the fork tube.
(1 screws and 1 nuts)(1)
N
When re-installing, use a new nut.
Tightening torque: 10 Nm.
- Suspend or immobilize the machine
securely.
- Remove the front mudguard.
- Remove the front brake caliper from the fork
tube.
Tightening torque: 10 Nm.
- Remove the front wheel.
N
When re-installing, use a new nut.
Tightening torque: 10 Nm.
- Remove the brake control cable grommet
and the speed sensor located under the fork
triple clamp. (2)(2 screw)
- Using tool P/N 757860 remove the steering
locknut.
- Remove:
• The lock washer.
• The nut.
• the rubber washer.
• The nut.
• The dust cover.
• The upper cone.
- Remove the fork.
- Remove the caged ball bearings.
34
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
757860
2
757860