Installing The Fork; Steering System Tightening Method - PEUGEOT Tweet Workshop Manual

- Install the following new parts:
• The washer . (6)
• The dust cover (7).
• The fork cone (8).

Installing the fork

- Grease the cup bearing races.
- Install 26 balls (9) for the upper cup and 19 balls
for the lower cup.
- Fit the fork into the steering column.
- Install the adjustment cone.

Steering system tightening method

- Screw the adjustment cone until it comes into
contact with the balls.
- Tighten the adjustment cone by 2/8 to 3/8 of a turn.
Do not tighten the adjustment cone beyond
the recommended value to avoid damaging
the steering bearings.
- Install and tighten the locknut without altering the
adjustment.
Tightening torque: 20 Nm.
- Check that there is no play in the fork.
- Turn the fork from left to right to check that there are
no tight spots.
- Refit the other items in the reverse order to
disassembly.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
7
9
2/8
3/8
STEERING/FORK
8
6
47