PEUGEOT Tweet Workshop Manual page 45

Pre-assembly checks
- Clean all the parts with a degreasing agent:
• Biosane type ref. 754748.
• Or use an ultrasonic cleaning tank.
- Check the condition of the fork tube, there shall be no corrosion or impact marks, and the tube
shall be perfectly straight and clean.
Reassembly
- Fit the plain washer.
- Fit a new lightly greased lip seal using push
tool P/N 756057 (11).
- Install the retaining ring.
- Install the dust cover.
- Install the expansion stop spring (8).
- Install the calibrated hydraulic tube (7).
- Install the compression stop cone (6) on the
calibrated hydraulic tube.
- Fit the fork sleeve (5) to the slightly oiled fork
tube (12).
- Install the stanchion assembly screw (4) and
its seal.
Tightening torque: 25 Nm.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
756057
11
6
12
5
STEERING/FORK
7
8
4
5
43