PEUGEOT Tweet Workshop Manual page 39

- Remove the 2 screws that secure the
muffler.
Tightening torque: 15 Nm.
- Remove the complete exhaust system.
Use a new exhaust gasket.
- Remove the wheel spindle nut and washer.
- Remove the rear wheel.
When re-installing, use a new nut.
- Remove the brake linings (3).
- Remove the adjusting nut, the barrel (4) and
the brake control cable (5).
- Remove the brake arm (6), the brake
cam (7) and the spring.
Reassembly.
Lubricate the brake cam spindle and fit
it into the casing.
- Fit the brake arm (6) by aligning it with the
brake cam axis (7).
Tightening torque: 6 Nm.
- Slightly lubricate the brake cam and pin.
- Install the brake linings.
- Install the spring (8).
- Install the brake control cable, the barrel and
the adjusting nut (4).
- Install the wheel.
Tightening torque: 110 Nm.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
3
7
4
6
7
8
SERVICE OPERATIONS
5
6
4
37