ELECTRICITY
Removal of the regulator/Starter resistor
- Remove the front lower shield panel. See:
Range 4. page 21.
- Disconnect the battery.
- Remove:
• Regulator (1).
• The starter resistor (2).
Removal of the starter motor relay
- Remove the rear cover assembly. See:
Range 2. page 20.
- Disconnect the battery.
- Disconnect and remove the starter motor
relay (1).
Removal of the fuel gauge
- Remove the storage compartment. See:
Range 1. page 20.
- Disconnect the fuel gauge.
- Unscrew the fuel gauge locking plate (1).
- Remove the fuel gauge.
- Remove the rubber gasket.
When re-installing, use a new gasket.
52
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
2
1
1
1