Adding Toner; Assembly - Canon NP6317 Service Manual

CHAPTER 8 INSTALLATION
D.

Adding Toner

Step
1 Remove the door switch actuator.
2 Disengage the developing assembly, and
slide it until it stops.
3 Shake the toner cartridge well.
4 Open the developing assembly lid, and fit the
boss on the rear end of the toner cartridge
into the hole of the plate on the rear end of
the developing assembly; thereafter, pull the
toner cartridge to the front somewhat so that
it comes into contact with the boss found on
the left side of the front.
5 Hold the toner cartridge, and pull on the seal
to the front until it stops.
6 Tap lightly on the top of the toner cartridge
until all toner has fallen into the developing

assembly.

7 Remove the toner cartridge, and keep it in an
empty box.
8 Close the developing assembly lid, and slide
the assembly inside until it stops.
9 Turn the developing assembly lever clock-
wise to engage it.
10 Close the front cover.
11 Set a blank sheet of paper (A3/11"x17") on
the copyboard after the COPY START key
goes green, and make six to ten copies.
8-6
Work
COPYRIGHT © 1999 CANON INC.
Remarks
The operation causes the toner inside the
developing assembly to be stirred.
CANON NP6317 REV.0 APR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)