Reassembly Of The Platen Unit Assy - Brother SC-2000 Service Manual

2.9

Reassembly of the Platen Unit Assy

Set the platen unit on the film guide, as shown in Fig. 3.75.
Insert part A of the platen unit assy into the hole in the main chassis from the inside.
Then, insert part B of the platen unit assy into the hole on the opposite side of the
main chassis, and insert the platen unit assy into the two grooves of the main
chassis, with the projection of the bearing turned upwards, as shown in Fig. 3.76.
Set part C of the platen unit assy between the two ribs of the film path.
Main chassis
Bearing
Platen unit
Fig. 3.75
B
Fig. 3.76
III - 61
Film guide
Platen unit assy
C
A