Reassembly Of The Drawer Connector - Brother SC-2000 Service Manual

2. REASSEMBLY PROCEDURES
2.1

Reassembly of the Drawer Connector

Set free bush 50, and free bushes 15 and 70 on the holes in the main chassis, as
shown in Fig. 3.48.
Pass the drawer connector assy harness through hole A in the main chassis. Insert
the drawer connector into hole B, and secure it with the two screws, as shown in
Fig. 3.49.
Note: Insert the drawer connector so that its projection will be inserted into groove
D of the main chassis.
Main chassis
Main chassis
Free bush 50
Free bush 15
Free bush 70
Fig. 3.48
Fig. 3.49
III - 36
Drawer connector assy
Projection
Hole B
Groove D
Hole A